>попробуй autoselect ppp
>
>у тебя автоматом, по идее, должен подниматься PPP, если коннектишься с винды
>и стартовать интерактивный режим, если коннектишься терминалом. Да такой пункт не доступен. Вот что есть
yourname#conf t
Enter configuration commands, one per line. End with CNTL/Z.
yourname(config)#int asy 1
yourname(config-if)#?
Interface configuration commands:
access-expression Build a bridge boolean access expression
arp Set arp type (arpa, probe, snap) or timeout or log options
ase Configure ASE on an interface
async Async interface parameters
autodetect Autodetect Encapsulations on Serial interface
backup Modify backup parameters
bandwidth Set bandwidth informational parameter
bgp-policy Apply policy propagated by bgp community string
bridge-group Transparent bridging interface parameters
carrier-delay Specify delay for interface transitions
cdp CDP interface subcommands
clock Configure serial interface clock
compress Set serial interface for compression
crypto Encryption/Decryption commands
custom-queue-list Assign a custom queue list to an interface
dampening Enable event dampening
default Set a command to its defaults
delay Specify interface throughput delay
description Interface specific description
dialer Dial-on-demand routing (DDR) commands
dialer-group Assign interface to dialer-list
dot1q dot1q interface configuration commands
dot1x Interface Config Commands for IEEE 802.1X
down-when-looped Force looped serial interface down
eigrp EIGRP interface specific commands
encapsulation Set encapsulation type for an interface
eou EAPoUDP Interface Configuration Commands
exit Exit from interface configuration mode
fair-queue Enable Fair Queuing on an Interface
flow-sampler Attach flow sampler to the interface
full-duplex Configure full-duplex operational mode
half-duplex Configure half-duplex and related commands
help Description of the interactive help system
hold-queue Set hold queue depth
ip Interface Internet Protocol config commands
iphc-profile Configure IPHC profile
keepalive Enable keepalive
l2-filter Set Layer2 ACL for packet received by upper layer protocols
lapb X.25 Level 2 parameters (Link Access Procedure, Balanced)
llc2 LLC2 Interface Subcommands
load-interval Specify interval for load calculation for an interface
logging Configure logging for interface
loopback Configure internal loopback on an interface
macro Command macro
max-reserved-bandwidth Maximum Reservable Bandwidth on an Interface
mtu Set the interface Maximum Transmission Unit (MTU)
netbios Use a defined NETBIOS access list or enable name-caching
no Negate a command or set its defaults
ntp Configure NTP
peer Peer parameters for point to point interfaces
ppp Point-to-Point Protocol
priority-group Assign a priority group to an interface
pulse-time Force DTR low during resets
rate-limit Rate Limit
routing Per-interface routing configuration
serial serial interface commands
service-policy Configure QoS Service Policy
shutdown Shutdown the selected interface
snapshot Configure snapshot support on the interface
snmp Modify SNMP interface parameters
source Get config from another source
timeout Define timeout values for this interface
tms-class Group related information
traffic-shape Enable Traffic Shaping on an Interface or Sub-Interface
transmit-interface Assign a transmit interface to a receive-only interface
tx-ring-limit Configure PA level transmit ring limit
xconnect Xconnect commands
zone-member Apply zone name
yourname(config-if)#
Ставлю
yourname(config-if)#autodetect encapsulation ppp
не помогает. Хотя может не то ставлю:(