>[оверквотинг удален]
>>>core(dhcp-config)#default-router 10.0.0.2
>>>core(dhcp-config)#dns-server 10.0.0.2
>>>core(dhcp-config)#dns-server 10.0.0.4
>>>core(config)#do sh run
>>
>>На 2960 работает.
>>Может заодно подскажете как настроить DHCP на 2950? Там это не
>>проходит.
>
>Точно также. Нет там команды ip dhcp pool
Switch(config)#ip ?
Global IP configuration subcommands:
access-list Named access-list
accounting-list Select hosts for which IP accounting information is
kept
accounting-threshold Sets the maximum number of accounting entries
accounting-transits Sets the maximum number of transit entries
alias Alias an IP address to a TCP port
default-gateway Specify default gateway (if not routing IP)
dhcp-server Specify address of DHCP server to use
domain-list Domain name to complete unqualified host names.
domain-lookup Enable IP Domain Name System hostname translation
domain-name Define the default domain name
finger finger server
ftp FTP configuration commands
gdp Router discovery mechanism
gratuitous-arps Generate gratuitous ARPs for PPP/SLIP peer addresses
host Add an entry to the ip hostname table
host-routing Enable host-based routing (proxy ARP and redirect)
hp-host Enable the HP proxy probe service
http HTTP server configuration
icmp ICMP options
igmp IGMP options
local Specify local options
name-server Specify address of name server to use
radius RADIUS configuration commands
rcmd Rcmd commands
reflexive-list Reflexive access list
security Specify system wide security information
source-route Process packets with source routing header options
sticky-arp Allow the creation of sticky ARP entries
subnet-zero Allow 'subnet zero' subnets
tacacs TACACS configuration commands
tcp Global TCP parameters
telnet Specify telnet options
tftp tftp configuration commands
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(13)EA1, RELEASE SOFTWARE (fc1)
Но кто-то писал, что поддерживает DHCP. Вот и спрашиваю, может кто-то знает как настроить?